DIN 50324 PDF

More G The value of any wear test method lies in predicting the relative ranking of material combinations. Since the pin-on-disk test method does not attempt to duplicate all the conditions that may be experienced in service for example; lubrication, load, pressure, contact geometry, removal of wear debris, and presence of corrosive environment , there is no insurance that the test will predict the wear rate of a given material under conditions differing from those in the test. In this latter case, the results cannot be compared to the ILS data Table 2.

Author:Molkis Mezikasa
Country:Ghana
Language:English (Spanish)
Genre:Health and Food
Published (Last):26 April 2007
Pages:132
PDF File Size:2.39 Mb
ePub File Size:18.68 Mb
ISBN:150-3-60578-711-2
Downloads:2242
Price:Free* [*Free Regsitration Required]
Uploader:Tektilar



More G The value of any wear test method lies in predicting the relative ranking of material combinations. Since the pin-on-disk test method does not attempt to duplicate all the conditions that may be experienced in service for example; lubrication, load, pressure, contact geometry, removal of wear debris, and presence of corrosive environment , there is no insurance that the test will predict the wear rate of a given material under conditions differing from those in the test.

In this latter case, the results cannot be compared to the ILS data Table 2. Scope 1. Materials are tested in pairs under nominally non-abrasive conditions. The principal areas of experimental attention in using this type of apparatus to measure wear are described. The coefficient of friction may also be determined. Such a use of this standard is encouraged as a means to improve wear testing methodology. However, it must be clearly stated in any report that, while the directions and protocol in Test Method G99 were followed if true , the choices of test parameters were different from Test Method G99 values, and the test results were therefore also different from the Test Method G99 results.

No other units of measurement are included in this standard. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

MANUAL FLASH NIKON SB 800 ESPAOL PDF

DIN EN 50324-2:2002-12;VDE 0336-2:2002-12

Kigajar The ball is caused to rub against the disk 1mm stroke at a frequency of 50 Hz for 75 min. The value of any wear test method lies in predicting the relative ranking of material combinations. Stribeck Curve Stribeck curve is a plot between coefficient of friction and bearing number. Piston Ring Liner This test helps evaluate friction and wear parameters of piston ring liner material in presence of engine oils.

DEMONICA 3 PASSION UNLEASHED PDF

DIN 50324:1992-07

.

DEAN LEFFINGWELL AND DON WIDRIG MANAGING SOFTWARE REQUIREMENTS PDF

United Protective Technologies

.

Related Articles