All rights reserved. Reproduction in any form or by any means without permission is prohibited. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. Page 5: Chapter 1 Introduction Introduction Chapter 1 Korenix JetNet Series is a power over Ethernet rail switch that is specially designed for industrial or commercial applications.
|Published (Last):||11 March 2018|
|PDF File Size:||3.78 Mb|
|ePub File Size:||10.21 Mb|
|Price:||Free* [*Free Regsitration Required]|
Page 5: Package Contents Package Contents Please refer to the package contents list below to verify them against the checklist. JetNet V User manual Removable Terminal Block- installed on the device Wall-mount Kit 2 wall-mount bracket with screws Compare the contents of the industrial switch with the standard checklist above. If any Please refer to Figure-3 for further information. Table-1 provides the description of the LEDs status and their definitions for the switch.
Please refer to Table-2 for RJ pin assignment. Page Cabling The following figures show the cable schematic for straight-through type Figure-4 and crossover type Figure Inserting the wires, will detect the fault status including power failure or port link failure managed industrial switch only and from a Normally Close circuit.
Please refer to Figure-8 for the fault alarm contact, and Figure-9 shows the application example for the fault alarm operation. If the bracket is not screwed on the switch, please refer to Figure to screw it on the switch. Page Wall Mounting After the DIN-Rail bracket is screwed on the rear side of the switch, insert the top of the bracket into the rail. Then, lightly pull-down the bracket into the rail. Installation Steps 1.
Unpack the Industrial switch packing.
Korenix JetNet 3705 User Manual